Android ADK ET-MEGA2560

ET-MEGA2560 ADK is a new board in the Arduino family. To communicate, run Arduino boards through various Android OS devices, such as mobile phones or tablets.

Brand: ETT

Model: ET-MEGA2560 ADK

ET-MEGA2560 ADK is a new board in the Arduino family. To connect Arduino board communication via Android OS devices such as mobile phones or tablets using the AVR family, the ATMEGA2560 and MAX3421 series have been developed into Arduino boards with USB HOST to support USB DEVICE connectivity. The Andriod OS device is designed to accommodate the various I / O boards, as well as board sizes required by Arduino MEGA boards.

Board Features ET-MEGA2560 ADK

Use ATMEGA2560 as a board MCU, RUN frequency 16 MHz, 100PIN TQFP

256 KBYTE FLASH IN PROGRAMMING (8 KBYTE FOR BOOTLOADER) / 8 KBYTE SRAM / 4 KBYTE EEPROM

Arduino CUDA Arduino MEGA is 100% compatible with C ++ programming language. It supports both WINDOWS, LINUX and MACINTOSH OSX.

USB MINI connector uses FTDI's FTDI BRIDGE USB for communication and DOWNLOAD CODE data written from computer to board. Without purchasing any additional DOWNLOAD device, add 6 pin connector for programming PROGRAM directly to the MCU without going through the Arduino BOOTLOADER program.

ON BOARD USB HOST (use MAX3421) for USB DEVICE or Android device connection.

      - Supports development with ADK (Android Open Accessories Development Kit) when used with Android V2.3.4 or higher.

      - Supports development with Microbridge ADB (Android Debug Bridge) when used with Android V1.5 or higher.

54 PIN DIGITAL I / O (5V TTL LOGIC) with

      - 14 PIN can be programmed as PWM.

      - 16 PIN ANALOG INPUT (A / D size 10 BIT 16 channels)

      - 4 PORT UART (HARDWARE SERIAL PORT) 5V TTL LOGIC

      - 1 HARDWARE TWI (I2C) - 1 SPI HARDWARE (UP TO 8 MBPS)

The size of the PCB, the board and the position of the PIN CONNECTOR will match the standard of all Arduino MEGA boards, so it is compatible with all SHIELD boards with board manufacturers for all Arduino MEGA boards. PCB size 5.3 x 10.2 x 2.0 cm

Power SUPPLY 7-12V power supply to the board as a 2.5mm MAIL JACK. Use both AC or DC power. Use REGULATE 5V SWITCHING LM2575-5 reduce heat and REGULATE 3.3V LM1117-3V3.

Can be used with PORT USB power supply to work. In case of using the whole board is not more than 500mA, the circuit automatically selects the power supply on the board.

Information Support

  Downloand File

Douploads |  uplod

Downloand |  Downloand